Graduation Semester and Year
2005
Language
English
Document Type
Thesis
Degree Name
Master of Science in Mechanical Engineering
Department
Mechanical and Aerospace Engineering
First Advisor
Ping Bo Wang
Abstract
Assessment of structural damage based on changes in vibratory response characteristics has been researched for many years, with much attention directed toward the use of modal parameters. Modal responses contribute to form points of local minima in the frequency response of a system. The frequency and amplitude values corresponding to these points of minimum response can be analytically determined, experimentally measured, and shown to exhibit sensitivity to damage. This work was performed to investigate the possible contribution that explicitly targeted minimum response information could provide in a damage detection process. A simple 6-DOF discrete spring-mass system was used to conduct preliminary evaluation of various frequency-based techniques adapted for minimum response. The study was extended to the analysis of simulated transverse crack damage in a cantilever beam, followed by experimental evaluation. Relevant conclusions are given, and areas for future work are defined.
Disciplines
Aerospace Engineering | Engineering | Mechanical Engineering
License
This work is licensed under a Creative Commons Attribution-NonCommercial-Share Alike 4.0 International License.
Recommended Citation
Kirk, Jeffrey, "Investigation Of Minimum Response For Damage Assessment" (2005). Mechanical and Aerospace Engineering Theses. 180.
https://mavmatrix.uta.edu/mechaerospace_theses/180
Comments
Degree granted by The University of Texas at Arlington