Graduation Semester and Year
2022
Language
English
Document Type
Dissertation
Degree Name
Doctor of Philosophy in Aerospace Engineering
Department
Mechanical and Aerospace Engineering
First Advisor
Ankur Jain
Abstract
Infrared (IR) thermal imaging is widely used for non-contact temperature measurement in engineering. IR camera detects thermal emissions from the target surface in a certain wavelength range, which, using the known surface emissivity, can be converted to a pixel-by-pixel temperature map. Fluorescence imaging also works along similar lines. This Ph.D. dissertation contributes towards thermal imaging and thermal transport characterization in engineering devices/systems using infrared and fluorescence imaging. In the first two parts of this work, infrared thermal imaging is used for measuring thermal conductivity of thin wires and for spotting unusual activities in a three-dimensional integrated circuit (3D IC). In the third part, a fluorescence imaging technique is developed for non-contact temperature measurement of a Li-ion cell with the help of a standard camera (mobile or DSLR). Measuring and understanding thermal conductivity is key for thermal characterization of materials and for maximizing performance and thermal safety of engineering devices and systems. This study presents a comparative method for measuring thermal conductivity of a thin wire. The method is based on infrared thermography of the wire of interest suspended from a high temperature base. Through comparison of thermal response of the wire with that of a standard wire of known properties, thermal conductivity is measured for several wires in a broad range of thermal conductivity. Measurements are reported for both low thermal conductivity polymer wires and high thermal conductivity metal wires. In the second part, infrared thermal imaging along with image analysis algorithms have been used for hardware trojan detection in microprocessors. Modern microprocessors are highly susceptible to hardware and software Trojans. Such Trojan activities may slow down the microprocessor, or in a worse case, leak confidential data and incapacitate microprocessor functionality. In principle, abnormal circuit activity due to Trojan operation is expected to cause distortion in the temperature field of the IC due to Joule heating. This study carries out measurement of temperature field of the transistor plane of a two-die three-dimensional integrated circuit (3D IC) thermal test chip through backside infrared imaging. Four distinct image processing algorithms are evaluated and compared in terms of speed, accuracy and occurrence of false positives and negatives. Finally in the third part, analysis for accelerated aging has been carried out for a 21700-battery module using immersed cooling for heat dissipation. Results with immersed cooling are compared with the baseline case of cooling with just stagnant air. Multiple hypotheses are checked in order to find the reasons behind deteriorated performance in terms of life of the battery. These hypotheses are analyzed using theoretical modeling as well as experimental measurements. Electrochemical impedance spectroscopy (EIS) is carried out to check the possibility of lithium plating, one of the possible reasons for accelerated aging of specified batteries.
Keywords
Infrared thermography, 3D ICs, Li-ion cell
Disciplines
Aerospace Engineering | Engineering | Mechanical Engineering
License
This work is licensed under a Creative Commons Attribution-NonCommercial-Share Alike 4.0 International License.
Recommended Citation
Salvi, Swapnil Suryakant, "Infrared and Fluorescent Thermal Imaging and Thermal Transport Characterization of Engineering Devices and Systems" (2022). Mechanical and Aerospace Engineering Dissertations. 271.
https://mavmatrix.uta.edu/mechaerospace_dissertations/271
Comments
Degree granted by The University of Texas at Arlington