Graduation Semester and Year
2020
Language
English
Document Type
Thesis
Degree Name
Master of Science in Materials Science and Engineering
Department
Materials Science and Engineering
First Advisor
Choong-Un Kim
Abstract
This work aims to study the formation of Inter Metallic Compounds (IMC’s) and their growth rate in Brass and Al-Mg alloy. This diffusion couple consists of four elements Aluminum, Copper, Zinc and Magnesium. Aluminum and Copper are major diffusing elements. Brass-Aluminum bimetal is an advanced structural material and used as a cladding material. This bimetal is produced by cold roll bonding and is mechanically bonded. To increase the adhesive strength of these bimetal layers, the sample is subjected to heat treatment which leads to the formation of Inter Metallic Compounds (IMC). Heat treatments are generally done above the recrystallization temperature of the elements. The recrystallization temperature of the all the four elements with highest melting point is Copper (1085°C) which is about 270°C and the lowest melting point of the four elements is Zinc which is about 420°C. Hence the temperatures in between are good for heat treatment. In this research, temperatures 350°C and 400°C are chosen for heat treatment of samples. In first part of this research the samples are cut from a cold rolled bonded three-layer brass-aluminum bimetal. These samples are heat treated in a tube furnace at chosen temperatures of 350°C and 400°C for different lengths of times. SEM analysis of the finely polished sample surfaces showed five distinct layers of IMC in between brass and aluminum layers. In the second part of this work, EDS analysis and XRD analysis is done on samples to find the chemical composition of these identified five layers. It was also observed that the kirkendall voids that were present in the sample coalesced as the heat treatment time increased and formed as a crack. The formation of crack stopped diffusion of elements across IMC’s, when samples were heat treated at 400°C for more than 20 hours. It was also observed that, of the five layers formed, the layer adjacent to α-brass is found to be duplex brass and is formed because of uphill diffusion of zinc and the Mg2Cu6Al5 formed adjacent to CuAl2 is because of uphill diffusion of Magnesium. In the final part, trend analysis of IMC thickness is done. The obtained data is plotted as thickness vs square root of time. The resulting graphs show that the diffusion across IMC’s follows parabolic law.
Keywords
Intermetallic compound, Heat treatment, Diffusion, Uphill diffusion, Growth, Failure
Disciplines
Engineering | Materials Science and Engineering
License
This work is licensed under a Creative Commons Attribution-NonCommercial-Share Alike 4.0 International License.
Recommended Citation
Kota, Ratan, "STUDY OF INTERDIFFUSION AND GROWTH OF INTERMETALLIC COMPOUNDS IN BIMETALLIC LAYERS OF ALPHA BRASS AND Al-Mg ALLOY" (2020). Material Science and Engineering Theses. 119.
https://mavmatrix.uta.edu/materialscieng_theses/119
Comments
Degree granted by The University of Texas at Arlington